Technical Bulletin 8: (G2) Gocycle G2 Correct Charging Procedure

Description

Not following the proper recommended charging sequence may lead to charging problems. Incorrect charging may result in a battery failing to charge and in extreme cases can result in a damaged and irreparable battery. Batteries damaged through misuse are not covered under warranty.

Action Required

Following the correct charging sequence will ensure best performance. The proper charging sequence is explained in the Gocycle Owner’s Manual. An updated version is included below for reference.

When fully charged, unplug the charger and return the battery to Sleep Mode. DO NOT LEAVE THE BATTERY ON CHARGE FOR MORE THAN 24 HOURS. THE BATTERY WILL NOT ACCEPT FURTHER CHARGE UNTIL THE GOCYCLE HAS BEEN USED* ‘TOP-UP’ CHARGING WITHOUT FIRST RIDING MAY DAMAGE THE BATTERY *Gocycle motor must be activated for long enough to reduce the battery level by at least 1 LED

 

Reminder: Proper Charging Sequence

1.

Open the rubber charging port cover, as shown.

 

2.

While holding open the rubber charging port cover, insert the charging lead as shown.

3.

Plug the charger into mains electricity and turn on (where applicable). 

4.

The charger light will turn orange to indicate charging.

NOTE:

If this does not turn orange and the battery is not fully charged, ride the Gocycle and then repeat the charge sequence. 

 

5.

Charge time up to 5.5 hours.

DO NOT LEAVE THE BATTERY ON CHARGE FOR MORE THAN 24 HOURS.

 

6.

The battery charge level is displayed on the Gocycle dashboard. When fully charged, the dashboard will display 10 LEDs on the left side.

7.

When the battery is fully charged (10 LEDs showing on the dashboard display), turn off the mains electricity and/or unplug the charger. 

 

8.

Remove the charging lead and replace the rubber charging port cover.

 

9.

BEST PRACTISE!

With the battery fully charged and the charger disconnected, turn the battery off by placing it into Sleep Mode.

See section below, Returning the Battery to Sleep Mode for more information.

 

 

10.

Ensure that the rubber charging port cover is in place before riding.

 

Returning the Battery to Sleep Mode

BEST PRACTICE: The Gocycle will use power when stationary and in Operation Mode, or if left on charge after charging has completed. This will drain the battery. Best practice is to enter Sleep Mode to conserve battery—when not in use and the battery is fully charged.

NOTE: the battery will never enter Sleep Mode if the charger is plugged in. To enter Sleep Mode, first disconnect the charger.

 

11.

Press and hold the button until the right LEDs (3,4) begin to flash.

 

12.

LEDs (3,4) will continue to flash whilst the battery enters Sleep Mode. 

 

13.

All LEDs (1,2,3,4) will flash to confirm that the battery has entered Sleep Mode. 

 

14.

The LEDs will then remain off. 

 

15.

When in Sleep Mode no LEDs will display on the dashboard.

 

Can I Continue to Ride my Gocycle?

Yes. Following the proper charging instructions detailed both in the Gocycle Owner’s Manual and in this bulletin will ensure best performance of your Gocycle and Gocycle battery.